This is an Oregon Lumber Company 1.25" thick brick quarter turned hardwood floor installed over an old cobblestone street in between old buildings in Red Wing, MN with 3/4" thick plywood and studs over the old cobblestone. This was installed in a huge hallway between all the offices in the Red Wing Shoes Corporate Office.

16 Photos

Glued down 3/8 walnut flooring over concrete on the first floor store at the Mall of America, Bloomington MN.

5 Photos

Pre-finished 3/4" thick staple down herringbone pattern 5" wide oak wood floor with a 50-year finish warranty over nailed down 3/4" thick plywood and poly moisture barrier at the Aerie Store in the Burnsville Center, Burnsville, MN

48 Photos

This is an engineered 3/8" maple floor directly glued down to the concrete on the first floor of the MOA in a variety of radius stopping points.

5 Photos

This is a YMCA Gym Floor pictured from the start of the project to finish. We started out with laying 4mm poly on the base concrete slab, then we installed one layer of 1/2" thick plywood with rubber legs on the bottom in a straight direction. After that was installed we glued and stapled a second layer of 1/2" thick plywood going at a diagonal to give the floor superior strength and bounce. After the adhesive set we installed a glued down 2nd grade maple block floor and sanded and finished it with a super tough Poloplaz Gym Floor Finish. After the finish dried out we installed a 2.5" Wide Vinyl base with cove base adhesive and gave a beautiful and sparkling gym to the YMCA users.

48 Photos